M1525-BL Brushless Servo Amplifier
| Performance Characteristics |
|
| Peak Power | 3.75 kW |
| Peak Output Voltage | + -150 vdc (shut off @ 205 vdc) |
| Peak Output Current | + -25 amps (1 sec.) |
| Max. Continuous Current | + -15 amps (50 C), 19 amps (25 C) |
| Internal Shunt Regulator | 55 W continuous, 2.4 kW peak for 0.2 seconds |
| Encoder or Hall Comumutation | (ativates at 190 vdc) |
| Electrical Characteristics | |
| Input Signal Voltage | + -10 vdc (typ), + - 35 vdc (max) |
| System Gain | 0 to 5100 amps/volts - velocity mode 0 to 10.0 amp/volt - torque mode |
| Input Impedance | 40 K Ohms |
| Typical Input Drift | 10 u V/C |
| Bandwidth | 3 kHz with 1.2 mHy Inductance |
| Dead Band | Zero |
| Input Power Requirements | |
| Input Voltage | 60 - 170 vdc |
| Adjustments | |
| Peak Current Limit | 0 to 25 amps |
| RMS Current Limit | 0 to 19 amps |
| Signal Command Imput | Scaling |
| Balance | Zero velocity offset |
| Compensation | System response |
| Tachometer | Scaling |
| Diagnostics | |
| Bus Over Voltage | Red LED |
| Excessive RMS/Over Temp. | Red LED |
| Surge/Ground Fault | Red LED |
| Amplifier Operational | Green LED |
| Physical Characteristics | |
| Module Dimensions | 7.6 in. x 1.0 in. x 5.7 in. |
| Weight | 1.4 lbs. |
| Ambient Temperature | 0C to 50C |
| Shutdown Temperature | 80C at heat sink |
| Relative Humidity | 5 - 95% non-condensing |
OPTIONS AVAILABLE
- MULTIAXIS CONFIGURATIONS
- COMPATIBLE POWER SUPPLIES
- COMPATIBLE SERVOMOTORS, ENCODERS AND GEARMOTORS
- COMPLETE BRUSHED SYSTEMS ALSO AVAILABLE